University:
California State University, Northridge
Course:
BLAW 370 | Corporate Social Responsibility
Academic year:

2024
Views:

224

Pages:

3
Author:

Judsonpofq

NOCTI Sample Questions 1. Class C What fire extinguisher should be used on an electrical fire? 2. Immediate Danger Only When should a person with a serious electrical injury be moved? 3. A Grounded Mat Use this to prevent static electricity damage? 4. First Aid Procedures, Proper Han- What information is on a Material dling/Storage, & Product Reactivity Safety Data Sheet (MSDS)? 5. OSHA What govt. organization sets and enforces worksite safety & health standards? 6. Resistor This symbol indicates what? 7. Larger Value Resistor Which resistor will dissipate the least power when 2 resistors are parallel? 8. Isolation This diagram that represents what type of transformer? 9. 3.1 Amps How much current is going through 15.5 volts with a 5 Ohms resistance? 10. OR Gate Name the type of gate. 1/3 11. A + BC Reduce (A+B)(A+C) to the simplest Boolean form. 12. 1001010 What is the binary equivalent of the hexadecimal number 4A? 13. DIAC Name this symbol. 14. Resistance Every digital multimeter can measure 3 basic things: current, voltage, and ___________. 15. Ammeter Measure a current with this instrument. 16. Triangle A function generator produces 3 basic wave shapes: sine, square, and ___________. 17. 20 to 20,000 Hz The frequency range of an audio signal generator. 18. 396 watts The power of an electronic device that runs on 36-volt supply and takes 11 amps. 19. Sum of the power dissipated by the The total power of a circuit. resistors 20. 1.414 volts The RMS is ______if the peak value of a given AC waveform is 2 volts. 21. Step-up A ______transformer has more secondary turns than primary turns. 22. Doubled 2/3 If resistance remains the same and voltage is doubled in an AC circuit, then the current is _________. 23. Full cycle The period of given AC waveform is the time for one of these. 24. Routing process All of the connections that are shown on a schematic must be made in the copper on the printed circuit board. 25. Wiped clean Prior to inning the tip with silver, the tip should be ______. 26. Quality Control Engineer The person who is responsible for product manufacturing reliability and the assurance of accuracy. 27. BS in Engineering Technology This degree is required to begin a career in biomedical engineering. 3/3