Two-Solvent Recrystallization Guide | Massachusetts Institute of Technology

University:
Massachusetts Institute of Technology
Course:
5.301 | Chemistry Laboratory Techniques
Academic year:

2022
Views:

266

Pages:

2
Author:

Davion Mueller

Two-Solvent Recrystallization Guide Overview: For a two-solvent recrystallization, you should have one solvent (solvent #1) in which your desired compound is soluble at the boiling point. The second solvent (solvent #2) should induce crystallization when added to a saturated solution of your compound in the primary solvent. Reference: See Zubrick pages 105-106, Mohrig 183-197 Recrystallization Steps: 1) The first step is to remove insoluble material from your compound by filtration. 2) Transfer the material to a 50-mL Erlenmeyer flask, equipped with a stir bar. Add an excess amount of solvent #1 (about 20 mL in this case) and heat to boiling on a stir/hot plate. The excess solvent is used to keep your compound from precipitating during the filtration. 3) Filter off the insoluble contaminant through fluted filter paper in a pre-warmed stemless funnel (pre-warm by adding some hot solvent just before you filter your solution, thus preventing loss of material on the filter paper.) 4) Wash the flask and filter paper with about 2 mL of hot solvent. 5) Reduce the volume of your solution to about 15 mL by boiling off the excess solvent. 6) Cool to room temperature. At this point, you probably do not have a saturated solution, so crystallization will not occur. 7) Add solvent #2 dropwise until the solution just becomes cloudy. Again heat the solution to the boiling point (with stirring!) and continue the addition of solvent #2. After each drop, you will notice a cloudiness that dissolves away. Continue dropwise addition of solvent #2 until the solution is saturated (i.e. if you were to add one more drop, the cloudiness would persist in solution: "super-saturated". If this happens, add a drop of your first solvent #1 to return to a clear solution. 8) Remove the flask from heat, fish out the stir bar with a magnet, allow to cool undisturbed to room temperature, then place in an ice bath. 9) Chill a mixture of your solvent system (in about the same ratio you used to obtain a saturated solution), which will be used to wash your crystals. 10) Collect your crystals on a small Büchner funnel by vacuum filtration, and rinse with the cold solvent mixture. 11) Pull air through the filter cake, then dry thoroughly in vacuo before obtaining a yield. One option to dry your product is to place it in a pre-weighed vial, and place the vial in a vacuum desiccator (you can cover the vial by fastening a Kimwipe on top with a rubber band).